At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Multi function street lamp Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Multi function street lamp It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.

The bulb shall be firm and upright and shall not be loose or skewed. If the enamel umbrella is corroded or deformed major Multi function street lamp It needs to be replaced in time. Before using electric tools, please check whether the wiring, plug, socket, grounding and leakage protection devices are in good condition. Do not use them if they are damaged. Safety slogans, warning signs and safety operation instruction boards shall be set up on the construction site. Materials on the site shall be stacked orderly and stably and handled from top to bottom. When using hand-held electric tools, please wear personal protective equipment and the power cord should be empty. It is forbidden for non operators to use it on site major Multi function street lamp Power switches, wires and various mechanical equipment. Outdoor construction is not allowed in rainy season. Outdoor construction should be carried out after the rain is dry. The Quality Safety Department is responsible for preparing labor protection articles to ensure the safety of construction personnel.

When the solar street lamp leaves the factory, the working time is generally set according to the customer's requirements. major Multi function street lamp The start and stop time of is determined by the street lamp controller. Most of the controllers are installed inside the light door, while most of the lithium battery storage and control integrated machines produced by our company are installed at the bottom of the solar panel. Controller adjustment is divided into manual adjustment and remote control adjustment. The external adjustment button can be adjusted manually. However, most of the current markets are remote control adjustment. This type of controller needs to be equipped with a remote control to adjust the working time. How to adjust major Multi function street lamp The time of also depends on the type of controller used.

LED panel light is a point shaped illuminant, which brings creative visual effects through the flexible design of points, lines and surfaces. It is light and thin, and can be installed on the ceiling, wall and the surface of the installation body, and suspended under the ceiling or the installation body. According to customer requirements, we can design light sources with different shapes and particles, which are flexible in design. High brightness major Multi function street lamp Light source, quick start, natural and soft light. It belongs to the category of lamps with strong anti vibration ability. The light source is a high hardness resin illuminant rather than tungsten glass, which is not easy to be damaged. Therefore, it has high anti vibration ability and strong adaptability to ambient temperature. major Multi function street lamp The uniform luminous reflective plate and sealed internal design are adopted, which are combined with the light guide plate and made of aluminum alloy materials. The effect is uniform and the lighting range is larger.

(1) Material requirements: an excellent energy-saving mining lamp is made of aluminum alloy with high thermal conductivity, and its surface is sprayed with anti-corrosion metal paint to ensure heat dissipation in the future. (2) Brightness requirements: according to different use environments major Multi function street lamp There are high requirements for the brightness of. Generally, the power used in normal space and large shopping centers is mostly 50w-100w lumens above 3000, and the brightness of the lights is selected according to the size of the area. (3) Heat dissipation performance: the quality of LED energy-saving mining lamp radiator has a great impact on its quality. We produce major Multi function street lamp The thickened and accurate automobile aluminum strong convection radiator is adopted, and the working mode is eddy current heat dissipation. The service life of the light source is largely guaranteed.