one major Rural lighting The charging circuit adopts a dual MOS series control circuit, which can reduce the voltage loss of the circuit by nearly half compared with the use of diodes. The use of PWM energy-saving control greatly increases the power consumption. 2. The load mode adopts pure light control. When the light is dark, the light sensor system will automatically light up. 3. Scientific battery management method. When over discharge occurs, the battery voltage will promote charging. After maintenance and compensation, it can be used normally. Direct charging and floating charging are used to connect rechargeable batteries. 4. All restrictions of all industrial chips and closed components can operate normally in cold, high temperature and humid environments. At the same time, major Rural lighting The use of crystal oscillator time control can make the time control more accurate.

LED garden lights are energy-saving and environmentally friendly. The main structure is an electroluminescent semiconductor diode, which has low luminous flux loss and long service life. According to the scientific research results of LED light source, major Rural lighting Its service life is three times that of the basic light source and 30% that of the energy-saving street lamp. Power saving is equal to saving the investment in electricity costs, and it is also because LED courtyard lamps have their unique advantages, which can meet the requirements of today's society for energy conservation and environmental protection. courtyard major Rural lighting The advantage of saving more electricity costs has a wide influence on the market. In order to improve people's quality of life, the street lamps that need to be used are energy-saving and environmentally friendly. Both specifications, lighting performance and lighting effect can meet the requirements of street lamp standards. Facing many LED garden lights with complex market environment, it is necessary to choose a good brand LED garden light manufacturer.

At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Rural lighting Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Rural lighting It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.

(1) Solar panel: 18v, 30-240wp monocrystalline silicon or polycrystalline silicon; (2) Controller: major Rural lighting Intelligent controller; (3) Battery: DC12V, 24V, lead-acid battery or gel battery, maintenance free; (4) Light source type: high-power LED integrated lamp head, die-casting aluminum material; (5) Light source power: 20-60W; (6) Light pole material: steel structure, hot-dip galvanizing, plastic spraying treatment; (7) Height: 6-8m; (8) Working time: 5-12 hours, 4-5 days in rainy days (different sunshine time in different regions); (9) Working temperature: - 35 ℃ - 65 ℃; In addition, major Rural lighting For the selection of solar panels and batteries, please refer to the purchase notes of solar street lamps. It can be seen that the selection of proper garden lamps is not only reasonable in price, but also comprehensive. In order to avoid unnecessary troubles.