The solar street lamp is composed of six main components: solar panel, lithium battery, controller, LED lamp holder, lamp pole and ground cage; major Floodlight It is made of LED lamp holder. It consists of three parts: lamp pole and grounding cage. Since the solar street lamp uses unique solar panel, lithium battery and controller components, it can easily get rid of the tedious wiring process in the building, complete the charging process independently, and automatically turn on and off the sunshine time according to the lighting conditions, or even automatically adjust the brightness of the street lamp according to the brightness in the daytime; However, urban circuit lights cannot get rid of the independent existence of municipal electricity. Cables need to be embedded at an early stage to ensure the subsequent installation of street lights. In order to control the lighting time, major Floodlight Power distribution can only be carried out on the mains. Time control can be installed on the box, and the brightness control of lighting can only be completed by adding corresponding only equipment.

1、 Disconnection. For "dead light", we should first determine major Floodlight Is it short circuit or open circuit. 2、 The adhesive layer is peeled off. For some LED energy-saving project lights with vertical chips, the common reasons for dead lights are the peeling off of the bottom of the chip bonding layer and the peeling off of the bracket coating. 3、 The welding spot is burnt. In some cases, the dead light of the bulb may not be caused by the bulb itself, but also by the power supply used. 4、 Chip corrosion. The previous energy-saving floodlights and energy-saving floodlights are open circuit. The following is the condition of short circuit dead light. major Floodlight There are many reasons for dead lights. Dead light may appear in every link from packaging, application to use.

1. Compared with traditional lamps, LED lighting has obvious energy-saving advantages. Just use major Floodlight The initial investment to replace traditional lamps has increased, but cost recovery can be achieved by saving electricity charges in a relatively short time. The earlier you replace it, the more you can enjoy the benefits of energy conservation. 2. The energy-saving performance of LED lighting is the choice to replace the traditional mining lamp. In the context of global energy contraction and the national conditions of governments at all levels to vigorously promote energy conservation and environmental protection, replacing traditional lamps will become major Floodlight The general trend of. There is a lot to do.

(1) Material requirements: an excellent energy-saving mining lamp is made of aluminum alloy with high thermal conductivity, and its surface is sprayed with anti-corrosion metal paint to ensure heat dissipation in the future. (2) Brightness requirements: according to different use environments major Floodlight There are high requirements for the brightness of. Generally, the power used in normal space and large shopping centers is mostly 50w-100w lumens above 3000, and the brightness of the lights is selected according to the size of the area. (3) Heat dissipation performance: the quality of LED energy-saving mining lamp radiator has a great impact on its quality. We produce major Floodlight The thickened and accurate automobile aluminum strong convection radiator is adopted, and the working mode is eddy current heat dissipation. The service life of the light source is largely guaranteed.