one major Industrial lighting The charging circuit adopts a dual MOS series control circuit, which can reduce the voltage loss of the circuit by nearly half compared with the use of diodes. The use of PWM energy-saving control greatly increases the power consumption. 2. The load mode adopts pure light control. When the light is dark, the light sensor system will automatically light up. 3. Scientific battery management method. When over discharge occurs, the battery voltage will promote charging. After maintenance and compensation, it can be used normally. Direct charging and floating charging are used to connect rechargeable batteries. 4. All restrictions of all industrial chips and closed components can operate normally in cold, high temperature and humid environments. At the same time, major Industrial lighting The use of crystal oscillator time control can make the time control more accurate.

1. Energy saving economy. First, each solar street lamp is a relatively independent system. In the process of installation and construction, there is no need to lay cables or dig roads, thus saving a lot of manpower, material resources and installation costs; In addition, it also consumes electricity, and ordinary street lights are on all day. The lamp lasts about 6 hours, consumes about 2 kWh, and the annual electricity charge is more than 300 yuan. According to 300 street lights in the urban area, the annual cost is nearly 100000 yuan. Can be saved major Industrial lighting 。 2. Energy conservation and environmental protection. Beijing major Industrial lighting It is mainly composed of four departments: photovoltaic module, light-emitting diode, solar cell and controller. Photovoltaic modules absorb light in the daytime, convert solar energy into electric energy, store it in solar cells, and release illumination when it turns dark at night.

First, we need to observe major Industrial lighting The workmanship of the mask and its luminous effect. This depends on how much light the bulb lamp shade emits to the light source. When viewing the mask, you can view its shape, whether the light transmittance and thickness of the bulb are the same, and check the approximate blur of the mask. We need to see if the material of the bulb is suitable for heat conduction. You can test in the field. After working for several minutes, observe whether there is odor above the bulb when the temperature rises. After that, we will also check the lamp body temperature after the power is turned off. The lower the temperature, the better. ordinary major Industrial lighting It will change due to the change of ambient temperature. When selecting bulb lamp, you need to check its color temperature. Generally speaking, the color temperature should not be too high or too low as long as it can meet the normal household lighting needs.

Computer modeling is used to simulate the luminous angle of the reflector light source and the spatial structure of the LED reflector, track the refraction track of light, and adjust the curvature of the reflector to achieve the light intensity distribution of the reflector The functional requirements of the LED light beam angle are greatly improved major Industrial lighting The light efficiency of the reflector reduces the possibility of astigmatism and glare. The reflective surface can be plated with orange peel and smooth. It can be more uniform and soft, without black holes, yellow circles. High reflection efficiency, no layering, high temperature resistance. The frosted mirror gently reflects light, which is suitable for occasions with weak light such as supermarkets and shopping centers. major Industrial lighting It is not applicable to places with high illumination requirements such as industries and stadiums. If it is used for industrial lighting, it needs a reflector with high refraction and luminous efficiency, and when the light passes through the reflector, it must reduce the light loss.