The life of LED mining lamp depends largely on the level of heat dissipation, and the main way to improve the level of heat dissipation is to transfer the excess heat generated by the chip through the radiator and radiator. At the same time, major Solar street lamp The main parameters related to LED heat dissipation are thermal resistance, junction temperature, temperature rise, etc. Thermal resistance is the quotient obtained by dividing the difference between the effective temperature of the equipment and the temperature of the external designated reference point by the steady-state power consumption in the equipment. It is an important parameter indicating the degree of heat dissipation of equipment. Junction temperature refers to the temperature of the semiconductor junction of the main heating part in the LED device. It reflects major Solar street lamp Temperature value that can be withstood under working conditions. Temperature rise refers to the temperature rise of the enclosure environment. It refers to the difference between the temperature of LED equipment shell and the ambient temperature. This is a temperature value that can be directly measured, which can directly reflect the heat dissipation degree around LED devices.

The bulb shall be firm and upright and shall not be loose or skewed. If the enamel umbrella is corroded or deformed major Solar street lamp It needs to be replaced in time. Before using electric tools, please check whether the wiring, plug, socket, grounding and leakage protection devices are in good condition. Do not use them if they are damaged. Safety slogans, warning signs and safety operation instruction boards shall be set up on the construction site. Materials on the site shall be stacked orderly and stably and handled from top to bottom. When using hand-held electric tools, please wear personal protective equipment and the power cord should be empty. It is forbidden for non operators to use it on site major Solar street lamp Power switches, wires and various mechanical equipment. Outdoor construction is not allowed in rainy season. Outdoor construction should be carried out after the rain is dry. The Quality Safety Department is responsible for preparing labor protection articles to ensure the safety of construction personnel.

The solar street lamp is composed of six main components: solar panel, lithium battery, controller, LED lamp holder, lamp pole and ground cage; major Solar street lamp It is made of LED lamp holder. It consists of three parts: lamp pole and grounding cage. Since the solar street lamp uses unique solar panel, lithium battery and controller components, it can easily get rid of the tedious wiring process in the building, complete the charging process independently, and automatically turn on and off the sunshine time according to the lighting conditions, or even automatically adjust the brightness of the street lamp according to the brightness in the daytime; However, urban circuit lights cannot get rid of the independent existence of municipal electricity. Cables need to be embedded at an early stage to ensure the subsequent installation of street lights. In order to control the lighting time, major Solar street lamp Power distribution can only be carried out on the mains. Time control can be installed on the box, and the brightness control of lighting can only be completed by adding corresponding only equipment.

If there is a problem with the solar street lamp in the countryside, first check whether the photocell is correctly connected, whether the wiring position is in poor contact, and then check whether the battery connection is correct and whether the battery voltage is normal. If the battery is excessively discharged, a fault will occur and it will automatically recover after being fully charged. Among them, major Solar street lamp The stability of the controller is very important for the service life of rural solar street lights, because the role of the solar controller is to control the use major Solar street lamp The battery board charges and discharges the battery. When choosing a solar cell, you must choose a high stability battery to ensure the service life of the battery, because the quality of the battery will also directly affect the service life of the street lamp. It can extend the service life of the whole rural solar street lamp.

(1) Material requirements: an excellent energy-saving mining lamp is made of aluminum alloy with high thermal conductivity, and its surface is sprayed with anti-corrosion metal paint to ensure heat dissipation in the future. (2) Brightness requirements: according to different use environments major Solar street lamp There are high requirements for the brightness of. Generally, the power used in normal space and large shopping centers is mostly 50w-100w lumens above 3000, and the brightness of the lights is selected according to the size of the area. (3) Heat dissipation performance: the quality of LED energy-saving mining lamp radiator has a great impact on its quality. We produce major Solar street lamp The thickened and accurate automobile aluminum strong convection radiator is adopted, and the working mode is eddy current heat dissipation. The service life of the light source is largely guaranteed.

How to reduce the risk of theft of Shandong solar street lights? Lanyue Optoelectronics Co., Ltd. recommends that you take the following measures: (1) major Solar street lamp Its cost is higher than that of traditional street lamp poles, and its anti-theft and stability technology is not mature enough. They should be installed in public places or relatively safe places in cities. It is not easy to install them in suburbs; (2) Among all the components, the battery is the part that is easy to be stolen. Therefore, we can bury the battery underground, under the building as far as possible, and then pour it in with cement, which can achieve good results. Anti-theft effect; (3) Attach importance to major Solar street lamp Security monitoring, establish monitoring systems or install alarm systems in places prone to theft, timely understand the use of solar street lights, and carry out effective management;