The life of LED mining lamp depends largely on the level of heat dissipation, and the main way to improve the level of heat dissipation is to transfer the excess heat generated by the chip through the radiator and radiator. At the same time, major Intelligent industrial lighting The main parameters related to LED heat dissipation are thermal resistance, junction temperature, temperature rise, etc. Thermal resistance is the quotient obtained by dividing the difference between the effective temperature of the equipment and the temperature of the external designated reference point by the steady-state power consumption in the equipment. It is an important parameter indicating the degree of heat dissipation of equipment. Junction temperature refers to the temperature of the semiconductor junction of the main heating part in the LED device. It reflects major Intelligent industrial lighting Temperature value that can be withstood under working conditions. Temperature rise refers to the temperature rise of the enclosure environment. It refers to the difference between the temperature of LED equipment shell and the ambient temperature. This is a temperature value that can be directly measured, which can directly reflect the heat dissipation degree around LED devices.

major Intelligent industrial lighting Coordination of color temperature and illuminance. The color temperature of light source is the color expression of light, major Intelligent industrial lighting The psychological effects of light color on people include cooling and heating effects and other expansion effects. The cooling and warming effect is based on the blue-green and red orange as the two extreme values of "cold color" and "warm color". It is generally believed that red has a warm feeling, while cyan has a cold and muddy feeling. The color temperature should be selected to achieve the desired lighting effect as to what kind of nightscape environment atmosphere needs to be created. The influence of color temperature on people is not only the feeling of cold and warm, but also the environmental illuminance. At low illumination levels, warm light with low color temperature is more acceptable, while at higher illumination levels, cool light with higher color temperature is more popular.

1. The installation height of LED energy-saving mining lamp is determined according to the environment, because the environment will change the reflection efficiency of the lamp. Generally, the height of LED energy-saving ceiling lamp should be more than 5 meters, and the wires should not be close to the enclosure of the ceiling. If necessary, install it. If it is less than 3m, protective measures shall be taken to prevent the vehicle from contacting it. two major Intelligent industrial lighting Waterproof and low-temperature treatment. Select the ceiling lamp with waterproof function and waterproof transformer. The chip package of the bulb is wrapped with high temperature insulating material, which can not only be waterproof, but also prevent the bulb from being damaged at low temperature under harsh conditions. three major Intelligent industrial lighting manufactor Use flat hard copper wire to connect the main line of LED energy-saving mining lamp wiring to the lamp, install one in five rings, and connect them evenly to three phase lines according to the load balance requirements.

When the solar street lamp leaves the factory, the working time is generally set according to the customer's requirements. major Intelligent industrial lighting The start and stop time of is determined by the street lamp controller. Most of the controllers are installed inside the light door, while most of the lithium battery storage and control integrated machines produced by our company are installed at the bottom of the solar panel. Controller adjustment is divided into manual adjustment and remote control adjustment. The external adjustment button can be adjusted manually. However, most of the current markets are remote control adjustment. This type of controller needs to be equipped with a remote control to adjust the working time. How to adjust major Intelligent industrial lighting The time of also depends on the type of controller used.