The solar street lamp is composed of six main components: solar panel, lithium battery, controller, LED lamp holder, lamp pole and ground cage; major Mining lamp It is made of LED lamp holder. It consists of three parts: lamp pole and grounding cage. Since the solar street lamp uses unique solar panel, lithium battery and controller components, it can easily get rid of the tedious wiring process in the building, complete the charging process independently, and automatically turn on and off the sunshine time according to the lighting conditions, or even automatically adjust the brightness of the street lamp according to the brightness in the daytime; However, urban circuit lights cannot get rid of the independent existence of municipal electricity. Cables need to be embedded at an early stage to ensure the subsequent installation of street lights. In order to control the lighting time, major Mining lamp Power distribution can only be carried out on the mains. Time control can be installed on the box, and the brightness control of lighting can only be completed by adding corresponding only equipment.

At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Mining lamp Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Mining lamp It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.

1. Advocate the concept of environmental protection and recycling globally. Traditional lamps contain many harmful substances. If the bulb fails, harmful substances will volatilize into the atmosphere. But, Beijing major Mining lamp It does not contain harmful substances at all and can protect the environment. Shandong LED ceiling lamp is recognized as a green lighting product in the 21st century. 2. Shandong LED mining lamp saves energy, has a long service life and saves maintenance costs. The power consumption of LED industrial and mining lamps in Shandong Province is generally less than one third of that of traditional lamps, and their service life is 10 times that of traditional lamps. It can be used for a long time without replacement, thus reducing the labor cost. 3， Beijing major Mining lamp It can also protect eyesight. Traditional lamps use AC power, but Shandong LED industrial and mining lamps directly convert AC power to DC power without flickering, which can protect the eyes. 4. Shandong LED mining lamp has high efficiency and luminous efficiency.

1. Compared with traditional lamps, LED lighting has obvious energy-saving advantages. Just use major Mining lamp The initial investment to replace traditional lamps has increased, but cost recovery can be achieved by saving electricity charges in a relatively short time. The earlier you replace it, the more you can enjoy the benefits of energy conservation. 2. The energy-saving performance of LED lighting is the choice to replace the traditional mining lamp. In the context of global energy contraction and the national conditions of governments at all levels to vigorously promote energy conservation and environmental protection, replacing traditional lamps will become major Mining lamp The general trend of. There is a lot to do.

1、 Disconnection. For "dead light", we should first determine major Mining lamp Is it short circuit or open circuit. 2、 The adhesive layer is peeled off. For some LED energy-saving project lights with vertical chips, the common reasons for dead lights are the peeling off of the bottom of the chip bonding layer and the peeling off of the bracket coating. 3、 The welding spot is burnt. In some cases, the dead light of the bulb may not be caused by the bulb itself, but also by the power supply used. 4、 Chip corrosion. The previous energy-saving floodlights and energy-saving floodlights are open circuit. The following is the condition of short circuit dead light. major Mining lamp There are many reasons for dead lights. Dead light may appear in every link from packaging, application to use.