1. Compared with traditional lamps, LED lighting has obvious energy-saving advantages. Just use major Plant lighting The initial investment to replace traditional lamps has increased, but cost recovery can be achieved by saving electricity charges in a relatively short time. The earlier you replace it, the more you can enjoy the benefits of energy conservation. 2. The energy-saving performance of LED lighting is the choice to replace the traditional mining lamp. In the context of global energy contraction and the national conditions of governments at all levels to vigorously promote energy conservation and environmental protection, replacing traditional lamps will become major Plant lighting The general trend of. There is a lot to do.

1. Quality assurance, green and environmental protection, our LED lamp has a long life, low light attenuation and high brightness. They are the first choice for energy-saving transformation of factories. 2. Energy saving. The service life of Danohangpu LED products can reach 50000 hours, and the energy-saving effect is 40% - 60% of that of ordinary lamps, greatly reducing the power consumption. 3. Professional major Plant lighting Plan and plan. Make a reasonable lighting configuration plan according to the width of the road and the lighting time of the area, so that you will not waste money and reasonably configure the light source. 4. Professional technical guidance and after-sales service, professional technical team major Plant lighting We provide on-site technical guidance and problem solving for the installation and transformation of. Perfect after-sales service is our intimate guarantee for users. 5. From the manufacturer to the manufacturer, shorten the intermediate link, and directly solve the problem that dealers do not understand the technology and the price is slightly higher from the manufacturer's plan - product customization - product inspection - product delivery - manufacturer acceptance, and one-stop service.

fixed major Plant lighting There are many methods, such as ceiling, embedded, hoisting (straight pipe or chain) and wall absorption. Generally, open lamps are usually used indoors. Enamel surface reflector shall be selected, with thick aluminum oxide film or aluminum reflector coated with silicon dioxide protective film. Movable local illuminators are equipped with corresponding handles, hooks, clamps, etc. Fixed local illuminators are usually firmly locked on the working machine by screws or fixing mechanisms. For large factories and large machine tool places requiring separate lighting major Plant lighting Reflectors made of materials with strong light control characteristics, such as prismatic glass, mirror glass and polished aluminum, to obtain narrow beam distribution.

1、 Disconnection. For "dead light", we should first determine major Plant lighting Is it short circuit or open circuit. 2、 The adhesive layer is peeled off. For some LED energy-saving project lights with vertical chips, the common reasons for dead lights are the peeling off of the bottom of the chip bonding layer and the peeling off of the bracket coating. 3、 The welding spot is burnt. In some cases, the dead light of the bulb may not be caused by the bulb itself, but also by the power supply used. 4、 Chip corrosion. The previous energy-saving floodlights and energy-saving floodlights are open circuit. The following is the condition of short circuit dead light. major Plant lighting There are many reasons for dead lights. Dead light may appear in every link from packaging, application to use.