1、 Disconnection. For "dead light", we should first determine major Smart street lamp Is it short circuit or open circuit. 2、 The adhesive layer is peeled off. For some LED energy-saving project lights with vertical chips, the common reasons for dead lights are the peeling off of the bottom of the chip bonding layer and the peeling off of the bracket coating. 3、 The welding spot is burnt. In some cases, the dead light of the bulb may not be caused by the bulb itself, but also by the power supply used. 4、 Chip corrosion. The previous energy-saving floodlights and energy-saving floodlights are open circuit. The following is the condition of short circuit dead light. major Smart street lamp There are many reasons for dead lights. Dead light may appear in every link from packaging, application to use.

1. Lamp holder: it needs to be sealed through the lamp holder. major Smart street lamp The waterproof treatment of lamp cap can ensure the service life of street lamp. Therefore, the selection of street lamp housing is very important. 2. Controller: when selecting, pay attention to whether the style is waterproof. When installing the controller, it is usually placed in the road to better avoid wind and sun exposure. 3. Battery: it needs to have certain waterproof performance. In order to install the battery, please bury the battery about 40cm underground to avoid flooding. After that, test major Smart street lamp Head to check whether the street lamp lights up normally. If it is opened, it can be used normally; otherwise, it needs to be replaced. Light poles need to be hot-dip galvanized to ensure smooth surface, no color difference, no pinholes, and no skin peeling after use.

The ultraviolet ray of LED energy-saving lamps is not particularly strong. major Smart street lamp It will not appear after using for a period of time. It may feel particularly strong and will not produce ultraviolet light, so it will not fade, will not be disturbed by mosquitoes, and the indoor sanitation can also become clean. major Smart street lamp It can also protect our eyes well. When starting, the time is faster, so it will not flash, so it can protect the eyes. The main advantage is that it can save power and has a longer service life. This is a good and reasonable guarantee. When you use it, you don't have to worry about life problems or abnormalities, nor about the cost of replacing the bulb. Moreover, when you use it, it is relatively robust and does not worry about frequent use. This would be bad.

1. Be able to monitor the temperature of the light source chip pad of the street lamp itself or the temperature of the lamp shell and conduct fault diagnosis; 2. Remote measurement of electrical parameters such as street lamp current and voltage, remote switching of street lamps, remote viewing of on-site operation of important road sections, etc; 3. According to major Smart street lamp The monitoring data of can timely grasp the abnormal position and reason of street lights, and carry out purposeful maintenance without having to go to the whole city for inspection, which speeds up the speed. 4. It has daylight sensor or on-board sensor dimming, energy saving control, time control and even RTC dimming; 5. In some areas with few people and vehicles, it can be controlled at half bright time in the middle of the night, but when people and cars pass by, major Smart street lamp They will reach the distance ahead and in a few cases restore the original brightness. Seconds. 6. The lighting standard level of the same road will change with time and traffic flow.

Reason 1: The cost of installing street lights on expressways is very high, and the installation distance of street lights is generally 30 meters to 40 meters. If the 50 meter street light is regarded as hundreds of kilometers on any expressway in China, the street light will be installed. major Smart street lamp The cost is very high. The second reason is that the expressway has a high safety factor. The expressway is a closed road connecting the city and the city. In the absence of pedestrians and non motorized vehicles, urban street lights are designed for the safety and convenience of non motorized vehicles and pedestrians. Third, automobile headlights and road reflective signs are sufficient to meet the lighting needs. Zhejiang major Smart street lamp Discontinuous and uneven. For drivers of high-speed vehicles, this kind of light dark alternation will cause visual illusion, which is very dangerous.