Considering that street lamps are conductors, one way is major City circuit lamp Combination of external lightning protection and internal lightning protection. As the material of street lamp is conductor, it is equivalent to lightning rod, and downlead and grounding grid need to be installed in the design. These systems constitute the external lightning protection system. After the completion of the external lightning protection system, the fire and personal safety accidents caused by the direct lightning stroke of the street lamp can be avoided. After the completion of external lightning protection, the internal lightning protection system can protect the equipment by grounding and setting voltage protection. major City circuit lamp The internal lightning protection system is ready to prevent induced lightning and other forms of overvoltage intrusion, which may damage the power supply. This is also beyond the protection of external lightning protection system. Therefore, the built-in internal protection and external protection can complement each other.

If there is a problem with the solar street lamp in the countryside, first check whether the photocell is correctly connected, whether the wiring position is in poor contact, and then check whether the battery connection is correct and whether the battery voltage is normal. If the battery is excessively discharged, a fault will occur and it will automatically recover after being fully charged. Among them, major City circuit lamp The stability of the controller is very important for the service life of rural solar street lights, because the role of the solar controller is to control the use major City circuit lamp The battery board charges and discharges the battery. When choosing a solar cell, you must choose a high stability battery to ensure the service life of the battery, because the quality of the battery will also directly affect the service life of the street lamp. It can extend the service life of the whole rural solar street lamp.

1. Advocate the concept of environmental protection and recycling globally. Traditional lamps contain many harmful substances. If the bulb fails, harmful substances will volatilize into the atmosphere. But, Guangzhou major City circuit lamp It does not contain harmful substances at all and can protect the environment. Shandong LED ceiling lamp is recognized as a green lighting product in the 21st century. 2. Shandong LED mining lamp saves energy, has a long service life and saves maintenance costs. The power consumption of LED industrial and mining lamps in Shandong Province is generally less than one third of that of traditional lamps, and their service life is 10 times that of traditional lamps. It can be used for a long time without replacement, thus reducing the labor cost. 3， Guangzhou major City circuit lamp It can also protect eyesight. Traditional lamps use AC power, but Shandong LED industrial and mining lamps directly convert AC power to DC power without flickering, which can protect the eyes. 4. Shandong LED mining lamp has high efficiency and luminous efficiency.

1. The installation height of LED energy-saving mining lamp is determined according to the environment, because the environment will change the reflection efficiency of the lamp. Generally, the height of LED energy-saving ceiling lamp should be more than 5 meters, and the wires should not be close to the enclosure of the ceiling. If necessary, install it. If it is less than 3m, protective measures shall be taken to prevent the vehicle from contacting it. two major City circuit lamp Waterproof and low-temperature treatment. Select the ceiling lamp with waterproof function and waterproof transformer. The chip package of the bulb is wrapped with high temperature insulating material, which can not only be waterproof, but also prevent the bulb from being damaged at low temperature under harsh conditions. three major City circuit lamp engineering Use flat hard copper wire to connect the main line of LED energy-saving mining lamp wiring to the lamp, install one in five rings, and connect them evenly to three phase lines according to the load balance requirements.