If there is a problem with the solar street lamp in the countryside, first check whether the photocell is correctly connected, whether the wiring position is in poor contact, and then check whether the battery connection is correct and whether the battery voltage is normal. If the battery is excessively discharged, a fault will occur and it will automatically recover after being fully charged. Among them, major Rural lighting The stability of the controller is very important for the service life of rural solar street lights, because the role of the solar controller is to control the use major Rural lighting The battery board charges and discharges the battery. When choosing a solar cell, you must choose a high stability battery to ensure the service life of the battery, because the quality of the battery will also directly affect the service life of the street lamp. It can extend the service life of the whole rural solar street lamp.

1. Advocate the concept of environmental protection and recycling globally. Traditional lamps contain many harmful substances. If the bulb fails, harmful substances will volatilize into the atmosphere. But, Taiwan major Rural lighting It does not contain harmful substances at all and can protect the environment. Shandong LED ceiling lamp is recognized as a green lighting product in the 21st century. 2. Shandong LED mining lamp saves energy, has a long service life and saves maintenance costs. The power consumption of LED industrial and mining lamps in Shandong Province is generally less than one third of that of traditional lamps, and their service life is 10 times that of traditional lamps. It can be used for a long time without replacement, thus reducing the labor cost. 3， Taiwan major Rural lighting It can also protect eyesight. Traditional lamps use AC power, but Shandong LED industrial and mining lamps directly convert AC power to DC power without flickering, which can protect the eyes. 4. Shandong LED mining lamp has high efficiency and luminous efficiency.

fixed major Rural lighting There are many methods, such as ceiling, embedded, hoisting (straight pipe or chain) and wall absorption. Generally, open lamps are usually used indoors. Enamel surface reflector shall be selected, with thick aluminum oxide film or aluminum reflector coated with silicon dioxide protective film. Movable local illuminators are equipped with corresponding handles, hooks, clamps, etc. Fixed local illuminators are usually firmly locked on the working machine by screws or fixing mechanisms. For large factories and large machine tool places requiring separate lighting major Rural lighting Reflectors made of materials with strong light control characteristics, such as prismatic glass, mirror glass and polished aluminum, to obtain narrow beam distribution.

At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Rural lighting Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Rural lighting It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.

major Rural lighting Corresponding rules and regulations shall be formulated for construction, and construction personnel shall strictly abide by the rules and regulations. Follow the instructions of the on-site construction personnel and complete the production tasks together. Expressway safety slogans, warning signs, etc. shall be set around the buildings, and shall not be removed or moved at will. Their movement shall be approved by the on-site construction director. The installation height of lamps shall be consistent. Install according to the design requirements. major Rural lighting The height of should be equal to the width of the road to be lit. Bench drills, toothless saws, cutting machines, etc., as well as electric tools for processing, need to be equipped with leakage protection devices. The elevation angle of the lamp is determined by the street width and light distribution curve of the lamp, and the elevation angle of each lamp needs to be the same. The place where resin glue and paint are stored shall be far away from fire sources, and sufficient fire-fighting equipment shall be placed.