Main pole of high pole lamp: major Cast light When the height of the main pole exceeds 20m, the steel plate with a wall thickness of 5.6mm is usually used as the main material. After the overall welding of the high pole lamp, the internal and external surface layers need to be hot-dip galvanized and qualified galvanized. This process can ensure that the main pole will not rust for 15 years. Lifting system: the lifting system is regarded as the core part of the high pole lamp. The landing action of the light panel depends entirely on the landing system. The landing system of high pole lamp is mainly hoist and wire rope. First, install the elevator on the main rod. Weathering and rain will not cause line aging. Secondly, the hoist seldom starts. If major Cast light If the light source has not been damaged in ten years, it will not need to be touched in ten years. Lamp cap: Whether it is LED lamp cap or low pressure sodium lamp, the light source is the main symbol of the whole set of high pole lamp. If the light source is broken and the high pole lamp is broken, the selection of light source quality is particularly important.

1. Strong anti-static capability: LED with strong anti-static capability has a long service life. 2. Brightness: The price of LED varies with its brightness. 3. Wavelength: LEDs with the same wavelength and color are expensive. 4. Luminescence viewpoint: LEDs for different purposes have different luminescence viewpoints. 5. LED chip: major Cast light The illuminant of is a chip, and the price of different chips varies greatly. 7. Colloid: Generally, the colloid of LED is epoxy resin. LEDs with UV resistance and flame retardancy are more expensive. 8. Chip size: the chip size is represented by the side length. Big chip major Cast light Its quality is better than that of small chips. The price is proportional to the chip size. 9. Radiator: The radiator can see the appearance of the lamp. Temperature will affect the life of LED lamp beads. Counting plays a vital role. 10. Power supply: According to the plan requirements of different manufacturers, it can be divided into two types: constant current power supply and constant voltage power supply.

1. When you buy back the LED ceiling lamp, please do not install it. Please read the label of the bulb carefully and read the installation manual, and then install and use the LED ceiling lamp according to the instructions, otherwise it may be dangerous. 2. Please be careful not to change it during cleaning and maintenance major Cast light Do not replace the parts of LED ceiling lamp at will. After cleaning and maintenance, install the bulb as it is, and do not omit or install the bulb components incorrectly; 3. Maintenance is required during use major Cast light To extend its service life. Wipe with dry cloth frequently, and pay attention to prevent moisture intrusion to avoid rust or long-term leakage and short circuit; Wipe as much as possible to avoid affecting light penetration.

If there is a problem with the solar street lamp in the countryside, first check whether the photocell is correctly connected, whether the wiring position is in poor contact, and then check whether the battery connection is correct and whether the battery voltage is normal. If the battery is excessively discharged, a fault will occur and it will automatically recover after being fully charged. Among them, major Cast light The stability of the controller is very important for the service life of rural solar street lights, because the role of the solar controller is to control the use major Cast light The battery board charges and discharges the battery. When choosing a solar cell, you must choose a high stability battery to ensure the service life of the battery, because the quality of the battery will also directly affect the service life of the street lamp. It can extend the service life of the whole rural solar street lamp.

1. Compared with traditional lamps, LED lighting has obvious energy-saving advantages. Just use major Cast light The initial investment to replace traditional lamps has increased, but cost recovery can be achieved by saving electricity charges in a relatively short time. The earlier you replace it, the more you can enjoy the benefits of energy conservation. 2. The energy-saving performance of LED lighting is the choice to replace the traditional mining lamp. In the context of global energy contraction and the national conditions of governments at all levels to vigorously promote energy conservation and environmental protection, replacing traditional lamps will become major Cast light The general trend of. There is a lot to do.