1. The installation height of LED energy-saving mining lamp is determined according to the environment, because the environment will change the reflection efficiency of the lamp. Generally, the height of LED energy-saving ceiling lamp should be more than 5 meters, and the wires should not be close to the enclosure of the ceiling. If necessary, install it. If it is less than 3m, protective measures shall be taken to prevent the vehicle from contacting it. two major Cast light Waterproof and low-temperature treatment. Select the ceiling lamp with waterproof function and waterproof transformer. The chip package of the bulb is wrapped with high temperature insulating material, which can not only be waterproof, but also prevent the bulb from being damaged at low temperature under harsh conditions. three major Cast light Price Use flat hard copper wire to connect the main line of LED energy-saving mining lamp wiring to the lamp, install one in five rings, and connect them evenly to three phase lines according to the load balance requirements.

How to reduce the risk of theft of Shandong solar street lights? Lanyue Optoelectronics Co., Ltd. recommends that you take the following measures: (1) major Cast light Its cost is higher than that of traditional street lamp poles, and its anti-theft and stability technology is not mature enough. They should be installed in public places or relatively safe places in cities. It is not easy to install them in suburbs; (2) Among all the components, the battery is the part that is easy to be stolen. Therefore, we can bury the battery underground, under the building as far as possible, and then pour it in with cement, which can achieve good results. Anti-theft effect; (3) Attach importance to major Cast light Security monitoring, establish monitoring systems or install alarm systems in places prone to theft, timely understand the use of solar street lights, and carry out effective management;

Considering that street lamps are conductors, one way is major Cast light Combination of external lightning protection and internal lightning protection. As the material of street lamp is conductor, it is equivalent to lightning rod, and downlead and grounding grid need to be installed in the design. These systems constitute the external lightning protection system. After the completion of the external lightning protection system, the fire and personal safety accidents caused by the direct lightning stroke of the street lamp can be avoided. After the completion of external lightning protection, the internal lightning protection system can protect the equipment by grounding and setting voltage protection. major Cast light The internal lightning protection system is ready to prevent induced lightning and other forms of overvoltage intrusion, which may damage the power supply. This is also beyond the protection of external lightning protection system. Therefore, the built-in internal protection and external protection can complement each other.

The solar street lamp is composed of six main components: solar panel, lithium battery, controller, LED lamp holder, lamp pole and ground cage; major Cast light It is made of LED lamp holder. It consists of three parts: lamp pole and grounding cage. Since the solar street lamp uses unique solar panel, lithium battery and controller components, it can easily get rid of the tedious wiring process in the building, complete the charging process independently, and automatically turn on and off the sunshine time according to the lighting conditions, or even automatically adjust the brightness of the street lamp according to the brightness in the daytime; However, urban circuit lights cannot get rid of the independent existence of municipal electricity. Cables need to be embedded at an early stage to ensure the subsequent installation of street lights. In order to control the lighting time, major Cast light Power distribution can only be carried out on the mains. Time control can be installed on the box, and the brightness control of lighting can only be completed by adding corresponding only equipment.

major Cast light Coordination of color temperature and illuminance. The color temperature of light source is the color expression of light, major Cast light The psychological effects of light color on people include cooling and heating effects and other expansion effects. The cooling and warming effect is based on the blue-green and red orange as the two extremes of "cold color" and "warm color". It is generally believed that red has a warm feeling, while cyan has a cold and muddy feeling. The color temperature should be selected to achieve the desired lighting effect as to what kind of nightscape environment atmosphere needs to be created. The influence of color temperature on people is not only the feeling of cold and warm, but also the environmental illuminance. At low illumination levels, warm light with low color temperature is more acceptable, while at higher illumination levels, cool light with higher color temperature is more popular.