1: Environment friendly lamp. LED products do not contain lead and other harmful substances, and the shell can also be recycled, which is harmless to the environment. 2: Fever is low. No UV, 3: no noise. LED light will not produce noise, so it is a good choice for occasions where quasi dense electronic instruments are used. 4: Protect eyes. major Smart street lamp LED constant current operation can effectively reduce LED light attenuation, start quickly, no flicker and protect eyes. 5: There is no trouble of mosquitoes, no harmful substances such as mercury, and less heat generated. 6: Wide voltage range. LED lights can be lit within a certain voltage range. 7: Power saving and long service life. It can be used for a long time without replacement, which reduces the labor cost. 8: Firm and reliable. major Smart street lamp It uses epoxy resin instead of traditional glass. 9: The appearance and size of multi-functional LED lamps are the same as those of traditional fluorescent lamps, which can replace traditional fluorescent lamps. 10: Rich color makes full use of the rich color of LED to make a variety of light emitting colors.

one major Smart street lamp The charging circuit adopts a dual MOS series control circuit, which can reduce the voltage loss of the circuit by nearly half compared with the use of diodes. The use of PWM energy-saving control greatly increases the power consumption. 2. The load mode adopts pure light control. When the light is dark, the light sensor system will automatically light up. 3. Scientific battery management method. When over discharge occurs, the battery voltage will promote charging. After maintenance and compensation, it can be used normally. Direct charging and floating charging are used to connect rechargeable batteries. 4. All restrictions of all industrial chips and closed components can operate normally in cold, high temperature and humid environments. At the same time, major Smart street lamp The use of crystal oscillator time control can make the time control more accurate.

1. When you buy back the LED ceiling lamp, please do not install it. Please read the label of the bulb carefully and read the installation manual, and then install and use the LED ceiling lamp according to the instructions, otherwise it may be dangerous. 2. Please be careful not to change it during cleaning and maintenance major Smart street lamp Do not replace the parts of LED ceiling lamp at will. After cleaning and maintenance, install the bulb as it is, and do not omit or install the bulb components incorrectly; 3. Maintenance is required during use major Smart street lamp To extend its service life. Wipe with dry cloth frequently, and pay attention to prevent moisture intrusion to avoid rust or long-term leakage and short circuit; Wipe as much as possible to avoid affecting light penetration.

At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Smart street lamp Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Smart street lamp It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.