At present, there are basically two kinds of sensors used for parking lot lighting. One is infrared sensor, which is relatively cheap. However, due to the height of the floor, the limitation of the metal tube and the influence of the radiation angle, the infrared sensor has a certain detection blind spot. The other is a microwave sensor, which can overcome the disadvantage of detecting corner blind areas, but the price is higher. These two sensors and major Solar lawn light Combined, the lighting energy saving of the underground parking lot is effectively realized. When someone moves the car under the light, major Solar lawn light It will run at full speed to meet the lighting demand. When there is no car and no car, the lamp is in a sleep state, and low power lighting of about 3W is maintained to maintain the required safety lighting. Low illumination, realizing energy saving of lighting.

one major Solar lawn light The charging circuit adopts a dual MOS series control circuit, which can reduce the voltage loss of the circuit by nearly half compared with the use of diodes. The use of PWM energy-saving control greatly increases the power consumption. 2. The load mode adopts pure light control. When the light is dark, the light sensor system will automatically light up. 3. Scientific battery management method. When over discharge occurs, the battery voltage will promote charging. After maintenance and compensation, it can be used normally. Direct charging and floating charging are used to connect rechargeable batteries. 4. All restrictions of all industrial chips and closed components can operate normally in cold, high temperature and humid environments. At the same time, major Solar lawn light The use of crystal oscillator time control can make the time control more accurate.

Using the integrated technology of LED electro-optic source, according to major Solar lawn light The characteristics of semiconductor luminescence, ingenious circuit design and unique lighting geometric appearance, major Solar lawn light It can save more than 80% of electricity, realizing effective energy saving. The ultra long service life is up to 50000 hours, which can be used well in various special environments (such as low temperature and high temperature conditions). It solves the problems of low power and insufficient brightness of semiconductor electric light source in the lighting field, and shows excellent high brightness characteristics. There is no need for ballast, no starting difficulty, complete overcurrent, overvoltage, short circuit, temperature, surge protection, and its lighting optical performance is brighter and more complete than 75W/400W/1000W metal halide lamp.

install major Solar lawn light The construction site shall be provided with safety slogans, warning signs and safety operation instruction boards, which shall not be removed or moved at will. Any movement shall be approved by the person in charge of site construction. When working on site, please pay attention to vehicle access and mechanical lifting. During normal construction, there should be no less than 2 people, and when there is only one person on site, no operation is allowed. Obey the instructions of on-site construction personnel, obey the assignment, unite and complete the production task. Materials on site shall be stacked neatly, and hazardous materials, chemical reagents and flammable materials must be placed separately. It is strictly prohibited to work in flammable and explosive places, open fire, smoking, etc. In operation major Solar lawn light Before that, please check whether the operation site is safe, whether the road is unblocked and whether the protective measures are complete. The tools used should be restored after the work is completed. Please wear safety belt when working at heights, cliffs and steep slopes without protective facilities.