LED energy-saving mining lamp, also known as LED energy-saving workshop lamp, is mainly used in factory workshops, stadiums, toll booths, etc. As the factory lamp is a kind of lighting tool, it is gradually accepted by most users. Factory lamps adopt new LED energy-saving technology, with high reflectivity and high power, but good lamps need standardized installation to highlight their advantages.
LED energy saving Mining lamp Installation: energy saving Mining lamp
1. The installation height of LED energy-saving mining lamp is determined according to the environment, because the environment will change the reflection efficiency of the lamp. Generally, the height of LED energy-saving ceiling lamp should be more than 5 meters, and the wires should not be close to the enclosure of the ceiling. If necessary, install it. If it is less than 3m, protective measures shall be taken to prevent the vehicle from contacting it.
2. Waterproof and low-temperature treatment of LED energy-saving mining lamp. Select the ceiling lamp with waterproof function and waterproof transformer. The chip package of the bulb is wrapped with high temperature insulating material, which can not only be waterproof, but also prevent the bulb from being damaged at low temperature under harsh conditions. It is very important to use LED energy-saving ceiling lights.
3. The manufacturer of LED energy-saving industrial and mining lamp uses flat hard copper wire to connect the main line of LED energy-saving industrial and mining lamp wiring to the lamp, install one in five rings, and connect them evenly to three phase lines according to the requirements of load balance. For high density lighting projects, the lampshade is only connected with PE protection wire.
What is the general installation distance of LED energy-saving ceiling lamp?
(1) Recommended installation height of 50W LED energy-saving mining lamp: 3-5 meters; Installation distance: 5-8m
(2) Recommended installation height of 100W LED energy-saving mining lamp: 6-8m; Installation distance: 8-10m
(3) 120W LED energy-saving mining lamp Recommended installation height: 8-10m; Installation distance: 8-10m
(4) Recommended installation height of 150W LED energy-saving mining lamp: 10-15m; Installation distance: 8-12m
(5) LED energy-saving mining lamp 200W Recommended installation height: 10-15m; Installation distance: 10-15m
(6) LED energy-saving mining lamp 300W recommended installation height: 15-20m; Installation distance: 20-25m
(7) Recommended installation height of 450W LED energy-saving mining lamp: 15-20m; Installation distance: 25-30m
The ultraviolet ray of LED energy-saving lamps is not particularly strong. Usually, the traditional light bulb may feel particularly strong after being used for a period of time, and will generate a lot of heat energy, so there will be more documents or books for a long time. LED energy-saving lamps will not be in this situation, nor will they produce ultraviolet light, so they will not fade, will not be disturbed by mosquitoes, and the indoor sanitation can also become clean.
LED energy-saving lamps can also protect our eyes well. When starting, the time is faster, so it will not flash, so it can protect the eyes. The main advantage is that it can save power and has a longer service life. This is a good and reasonable guarantee. When you use it, you don't have to worry about life problems or abnormalities, nor about the cost of replacing the bulb. Moreover, when you use it, it is relatively robust and does not worry about frequent use. This would be bad.
In addition, it can emit more colors, so it can be used in many fields and places to ensure the use of certain fields. Basically, it has a reasonable size and is similar to the traditional one, so it can replace the traditional one and is suitable for families, offices, etc.
