The use of lighting tools has brought great convenience to the rise of people. What are the regulations for highway lighting construction? Next, let's take a look at everyone!

Corresponding rules and regulations shall be formulated for construction, and construction personnel shall strictly abide by the rules and regulations. Follow the instructions of the on-site construction personnel and complete the production tasks together. Expressway safety slogans, warning signs, etc. shall be set around the buildings, and shall not be removed or moved at will. Their movement shall be approved by the on-site construction director. The installation height of lamps shall be consistent. Install according to the design requirements. The height of the lamp shall be equal to the width of the road to be illuminated. Bench drills, toothless saws, cutting machines, etc., as well as electric tools for processing, need to be equipped with leakage protection devices.

The elevation angle of the lamp is determined by the street width and light distribution curve of the lamp, and the elevation angle of each lamp needs to be the same. The place where resin glue and paint are stored shall be far away from fire sources, and sufficient fire-fighting equipment shall be placed. The bulb shall be firm and upright and shall not be loose or skewed. During transportation and installation, the reflector of the bulb shall not be damaged or deformed. The lamp shade shall be equipped with rubber ring, and the lamp shall be on. When the bulb socket is damaged and the copper wire is exposed, it should be replaced. Check various iron parts. If there is rust, crack, scar, etc., the paint surface shall be derusted and painted or galvanized. The vertical rubber wire shall be insulated rubber wire, and the overhead conductor shall overlap symmetrically on both sides of the pole, and both sides shall be consistent. It is prohibited to overlap the zero line of the vertical line of the street lamp with the zero line of the user's connection line, so as to prevent power supply from the user's meter when the zero line is disconnected.

Scaffolds shall be securely installed and used only after inspection and acceptance. On each crimping screw of capacitor and ballast, the ends of two wires can be pressed. The bending direction of the end of the conductor shall be clockwise and compacted with flat gasket. For lamps with ballasts and capacitors, fuses shall be installed outside the ballasts and fuses. The lamp cap and lamp tube flange shall be matched without cracks and scars, the screws shall be complete, and the bolt length shall be able to penetrate the lamp cap flange. If the weather is bad, it is necessary to stop working at heights in time. In addition to the above provisions, the above provisions shall also be observed. After installation, regular maintenance shall be carried out to extend its service life.

The above is the regulation of highway lighting construction. I hope the above content will help you. Welcome to inquire!